Welcome to the ultimate waterjet forum, WaterjetGroup.com!
This forum will give you access to participate in discussions and attain resources via our vibrant waterjet community . This discussion board is intended for any waterjet user but the majority of the moderators are associates of Flow International Corporation. We will attempt to make this community an unbiased source of information regarding general waterjet topic areas. If you are a registered Flow Waterjet customer and require in-depth product support, please visit FlowParts.com.
I purchased a used Bengal flow waterjet for my students to use , set up , can run in manual (pump on , high pressure) can cut in manual jog , there are lots of parts in the system from previous owner, just can't figure out how to get it to cut a part , I run cnc plasma cam , fadal cnc machine center, it preview cut , show the path it will take , pump will start (low pressure ) just cant figure how to get it to start the actual cut on a drawn part. Thanks
You prolly need a post processor in the same machine language as your new Jet. The G and M codes ( for example ) are most likely different for each control.
Please note, the views and recommendations expressed by employees of Flow or it's partners on this website do not necessarily represent those of Flow International Corporation. For more information on this site's Terms of Use , please visit the DXF Copyright and Community Guidelines pages.
Important: Do not upload any DXF's or images without permission unless they consist entirely of content you or your company created.
By clicking "Upload file", you are representing that this DXF or image does not violate the WaterjetGroup.com's forum's Terms of Use and that you own all copyrights to this file or have authorization to upload it.