Welcome to the ultimate waterjet forum, WaterjetGroup.com!
This forum will give you access to participate in discussions and attain resources via our vibrant waterjet community . This discussion board is intended for any waterjet user but the majority of the moderators are associates of Flow International Corporation. We will attempt to make this community an unbiased source of information regarding general waterjet topic areas. If you are a registered Flow Waterjet customer and require in-depth product support, please visit FlowParts.com.
i have a stremline slv-60.changed all the seals and rings on the piston,including check valves.hyd oil is 115 deg in holding tank.temp on heated parts (intensifier) should be 10 to 15 deg warmer than holding tank temp,so i was told.gona get a good reading on the intensifier shortly but if i had to guess,i would say that the temp was around150+.after it runs for about 20 min solid,you canthold your hand on it for more than 2-3 sec (hot).by the way i have good water flow through heat exchanger (cold).what do yall think the prob is????? thanks Shawn.
Not familiar with that pump, but will say, My Jet Edge 55-50 C was heating up. In an obvious common sense decision I went straight after the Heat exchanger. I even went so far as to replace it. (which was actually a 2 fold decision, I wanted one on the shelf for both pumps)., any way turns out that the booster pump had a tiny fracture, and I mean tiny, in it's Impeller. Apparently enough to reduce it's performance to the point of the overheating ,, 50 bux.
Bought 2 :P
Please note, the views and recommendations expressed by employees of Flow or it's partners on this website do not necessarily represent those of Flow International Corporation. For more information on this site's Terms of Use , please visit the DXF Copyright and Community Guidelines pages.
Important: Do not upload any DXF's or images without permission unless they consist entirely of content you or your company created.
By clicking "Upload file", you are representing that this DXF or image does not violate the WaterjetGroup.com's forum's Terms of Use and that you own all copyrights to this file or have authorization to upload it.