Welcome to the ultimate waterjet forum, WaterjetGroup.com!
This forum will give you access to participate in discussions and attain resources via our vibrant waterjet community . This discussion board is intended for any waterjet user but the majority of the moderators are associates of Flow International Corporation. We will attempt to make this community an unbiased source of information regarding general waterjet topic areas. If you are a registered Flow Waterjet customer and require in-depth product support, please visit FlowParts.com.
My guess: If it's a large enough area, it will show a number of things. I've cut a square of one inch thick steel, when the head was not straightened correctly. Examining the cut surface showed taper in the cut, like the whole piece was skewed in one direction from top to bottom. Without a careful examination like that, I would have cut a whole batch of bad pieces. Also, if your cut surface starts to get wobbly/bumpy (strafing?) it means that either your mixing tube or your orifice is going bad, or else you're cutting your material too fast, or you have a minor malfunction in your garnet delivery. Also it just looks really cool, like the inside of a fossil or something.
Please note, the views and recommendations expressed by employees of Flow or it's partners on this website do not necessarily represent those of Flow International Corporation. For more information on this site's Terms of Use , please visit the DXF Copyright and Community Guidelines pages.
Important: Do not upload any DXF's or images without permission unless they consist entirely of content you or your company created.
By clicking "Upload file", you are representing that this DXF or image does not violate the WaterjetGroup.com's forum's Terms of Use and that you own all copyrights to this file or have authorization to upload it.