Welcome to the ultimate waterjet forum, WaterjetGroup.com!
This forum will give you access to participate in discussions and attain resources via our vibrant waterjet community . This discussion board is intended for any waterjet user but the majority of the moderators are associates of Flow International Corporation. We will attempt to make this community an unbiased source of information regarding general waterjet topic areas. If you are a registered Flow Waterjet customer and require in-depth product support, please visit FlowParts.com.
HI. when i cut ss 6mm or 8mm or higher i have a big V-shaped taper and all size on square detail are rounded. taper has between up and down surface near 0.5 mm on 65x10x6mm detail. but when i use plexyglass 15mm same detail it's ok. i have flow mach2b with Pacer ECL plus, i use 1.02 mixed tube , diamond orifice 0.013 garnet mesh 80 with .246 metering disk (try also .206 .215 metering disk size as well) 47x1000 psi on my hyplex prime pump. it's started a few days ago, after when i change mixed tube on 0.76 and metering disk .154 and try cut 0.5mm aluminium. all tools (mixed tube, diamond orifice disk, metering disk) i change and put new.
Please note, the views and recommendations expressed by employees of Flow or it's partners on this website do not necessarily represent those of Flow International Corporation. For more information on this site's Terms of Use , please visit the DXF Copyright and Community Guidelines pages.
Important: Do not upload any DXF's or images without permission unless they consist entirely of content you or your company created.
By clicking "Upload file", you are representing that this DXF or image does not violate the WaterjetGroup.com's forum's Terms of Use and that you own all copyrights to this file or have authorization to upload it.