Welcome to the ultimate waterjet forum, WaterjetGroup.com!
This forum will give you access to participate in discussions and attain resources via our vibrant waterjet community . This discussion board is intended for any waterjet user but the majority of the moderators are associates of Flow International Corporation. We will attempt to make this community an unbiased source of information regarding general waterjet topic areas. If you are a registered Flow Waterjet customer and require in-depth product support, please visit FlowParts.com.
Running a flow 87k Jet. Hole are coming in 0.3 out of round on 1 axis. Using dynamic jet. Head clocked straight and only on hole's not on square's Any ideas lads
The problem is most likely that your A B motor bracket is not square. Probably no fault of your own. Flow's vender did not make them to print and Flow never checked them when they came in. This is after at least 20 visits from Flow technicians in the past year and a half that we found this out. They made us a stainless steel bracket which helped. There are also glaring software problems. Make sure to contact them and make them give you a bracket that is in spec and software upgrades. The software upgrades will give you a new set of problems but at least your holes will only be out of round about .005, .006"
Please note, the views and recommendations expressed by employees of Flow or it's partners on this website do not necessarily represent those of Flow International Corporation. For more information on this site's Terms of Use , please visit the DXF Copyright and Community Guidelines pages.
Important: Do not upload any DXF's or images without permission unless they consist entirely of content you or your company created.
By clicking "Upload file", you are representing that this DXF or image does not violate the WaterjetGroup.com's forum's Terms of Use and that you own all copyrights to this file or have authorization to upload it.