Waterjet Group

Welcome to the ultimate waterjet forum, WaterjetGroup.com!
This forum will give you access to participate in discussions and attain resources via our vibrant waterjet community . This discussion board is intended for any waterjet user but the majority of the moderators are associates of Flow International Corporation. We will attempt to make this community an unbiased source of information regarding general waterjet topic areas. If you are a registered Flow Waterjet customer and require in-depth product support, please visit FlowParts.com.

Members Login
Post Info TOPIC: granite/steel cutting on sawjet


Status: Offline
Posts: 1
granite/steel cutting on sawjet

I have a Northwood 257 saw jet that I use to cut granite.  Some people have expressed interest in me cutting steel and aluminum for them.  My question is has anyone on here cut steel or aluminum with the same machine?  What did you run into as far as the garnet?  I figure the feed rate is going to be pretty slow for thicker materials but what about 1/4" and under?  Any words of wisdom would be greatly appreciated!

Page 1 of 1  sorted by
Quick Reply

Please log in to post quick replies.

Please note, the views and recommendations expressed by employees of Flow or it's partners on this website do not necessarily represent those of Flow International Corporation. For more information on this site's Terms of Use , please visit the DXF Copyright and Community Guidelines pages.

Important: Do not upload any DXF's or images without permission unless they consist entirely of content you or your company created.

By clicking "Upload file", you are representing that this DXF or image does not violate the WaterjetGroup.com's forum's Terms of Use and that you own all copyrights to this file or have authorization to upload it.