Welcome to the ultimate waterjet forum, WaterjetGroup.com!
This forum will give you access to participate in discussions and attain resources via our vibrant waterjet community . This discussion board is intended for any waterjet user but the majority of the moderators are associates of Flow International Corporation. We will attempt to make this community an unbiased source of information regarding general waterjet topic areas. If you are a registered Flow Waterjet customer and require in-depth product support, please visit FlowParts.com.
I am cutting a round tank bottom that is going to be cut in two halfs. The weld procedure calls out a specific bevil of 37 degres with a 1/16 landing on the bottom. how would i draw this using flow expert design software?
Please note, the views and recommendations expressed by employees of Flow or it's partners on this website do not necessarily represent those of Flow International Corporation. For more information on this site's Terms of Use , please visit the DXF Copyright and Community Guidelines pages.
Important: Do not upload any DXF's or images without permission unless they consist entirely of content you or your company created.
By clicking "Upload file", you are representing that this DXF or image does not violate the WaterjetGroup.com's forum's Terms of Use and that you own all copyrights to this file or have authorization to upload it.