Waterjet Group

Welcome to the ultimate waterjet forum, WaterjetGroup.com!
This forum will give you access to participate in discussions and attain resources via our vibrant waterjet community . This discussion board is intended for any waterjet user but the majority of the moderators are associates of Flow International Corporation. We will attempt to make this community an unbiased source of information regarding general waterjet topic areas. If you are a registered Flow Waterjet customer and require in-depth product support, please visit FlowParts.com.

Members Login
Username 
 
Password 
    Remember Me  
Waterjet Group -> General Chat & Discussion -> flow dynamic
Post Info TOPIC: flow dynamic
Grahamjet


Member

Status: Offline
Posts: 6
Date:
flow dynamic
Permalink  
 

Currently have a flow dwj does anyone know where i can get a video for the strightness ajustment. Don't think i'm doing this the correct way as the holes are not to sizewhen using dwj.

 



__________________
perfpro


Member

Status: Offline
Posts: 11
Date:
Permalink  
 

You can check after you have done the straightness adjustment by manually jogging the mixing tube up and down on the dial guage. 

I use this method to check straightness before cutting any thicker sections, and before doing a straightness adjustment.

My problem is the holes are not coming out round.  I have replaced A and B axis servomotors some time ago, so I probably need to run the ball bar test.  Not sure where to get the equipment for this, or even the procedure for doing it.



__________________
DAF


Member

Status: Offline
Posts: 5
Date:
Permalink  
 

Flowparts.com  They have all the videos for the procedure and other procedures as well.



__________________
perfpro


Member

Status: Offline
Posts: 11
Date:
Permalink  
 

Great if you are in USA.
I am not sure about he rest of the world, but from Australia I can't get a log-on for Flowparts :(

__________________
Flow guy


Newbie

Status: Offline
Posts: 2
Date:
Permalink  
 

perfpro wrote:

Great if you are in USA.
I am not sure about he rest of the world, but from Australia I can't get a log-on for Flowparts :(

Please contact GWB for any service you needed in Australia

__________________
Page 1 of 1  sorted by
 
Quick Reply

Please log in to post quick replies.
Waterjet Group -> General Chat & Discussion -> flow dynamic
Please note, the views and recommendations expressed by employees of Flow or it's partners on this website do not necessarily represent those of Flow International Corporation. For more information on this site's Terms of Use , please visit the DXF Copyright and Community Guidelines pages.

Important: Do not upload any DXF's or images without permission unless they consist entirely of content you or your company created.

By clicking "Upload file", you are representing that this DXF or image does not violate the WaterjetGroup.com's forum's Terms of Use and that you own all copyrights to this file or have authorization to upload it.